Blade Removal

Blade Removal
You are here:
< Back

For optimal performance and life, the blade and bed bar must be removed and cleaned every few hours of operation (4 hours).

Step 1: Loosen the top two set screws with the 3/32″ Allen Wrench.
Step 2: Use the 5/32″ Allen Wrench to loosen and remove the appropriate bolts to release the blade from the Blade Adjustment Block.
Step 3: Remove the blade and the bed bar. Clean both with a utility knife and wipe clean with acetone.
Step 4: Place the bed bar back into position and make sure the magnets are facing up.
Step 5: Place the blade back into position and ensure the bevel is facing up.
Step 6: Ensure the edge of the blade bar is flush to the edge of the blade.

CenturionPro Marketing


Subscribe to receive emails from CenturionPro and be among the first to hear about new products, articles, videos and more.

reCAPTCHA is required.